Cervis TM70 Installationshandbuch PDF herunterladen (Seite 16)

TM70Bi.v1.1.doc (10/03) 15

ANNEX B.- PROGRAMMING THE MACHINE IDENTIFICATION IN LCD TRANSMITTERS.

Transmitters with the LCD display option permit the operator to program a machine

identification label of up to 24 characters. This identification displays upon transmitter start-

up.

When first starting the transmitter you can edit/introduce this text as follows;

1. Install a battery and turn the ON/OFF key

to ON.

2. Push in and then pull out the STOP

button. You will observe the LED pulse

orange followed by green pulses.

3. Press pushbutton 4 to the second step

and then push the START button. Keep

both pressed simultaneously for 2

seconds. You will enter the ‘EDITING’

mode.

4. Once you have entered the ‘EDITING’

mode, the display will indicate "CRANE

??" The first character blink will be

blinking. From this point you can edit the

name of the machine using pushbuttons 1

to 4 as follows:

 Pushbutton 1: Scroll the list of established characters in descending order.

 Pushbutton 2: Scroll the list of established characters in ascending order.

 Pushbutton 3: To return to the previous character in the display.

 Pushbutton 4: To validate the displayed character and move to the next character

to the right.

 Push START to store the edited text. LCD will show the message “SAVED” for 2

seconds.

5. Once the last character has been edited, you exit the ‘EDITING’ mode by pressing

the STOP button.

1 2 ... 11 12 13 14 15 16

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 16