Cervis TM70 Bedienungsanleitung PDF herunterladen (Seite 18)

TM70 Handheld Wireless Remote Control

Crane ID Label

Option: LCD Display

LED

Command Button

Contact Key

Start Button

Stop Button

Option: IR Range Limite

Figure 8. TM70 Transmitter Details

Table 4 below shows the receiver LEDs upon receiving a signal from the transmitter.

Table 4. Receiver LEDs Upon Receiving a Transmitter Signal

LED State Indication

POWER ON

Power supply is correct

HARKOK ON

Defects have not been detected on the board

SIGNAL ON

Channels are signal free

DATA ON

Data received has a correct format

ID ON

Receiver has recognized the transmitter ID code

3. Press any of the transmitter’s movement pushbuttons. Its corresponding

relay is energized. In case of an active movement, the safety relay

K1/SAFETY is also energized.

4. Check to make sure all the other movements work as described in Step 3.

5. Turn off the transmitter using the

STOP Button, and make sure that

when doing so the relays are not energized and the

DATA, ID, and

SIGNAL LEDs go out. They should behave exactly as when in the

SCANNING mode.

6. Reconnect the power supply to the motors, move to a safe position, and

check to see if all the movement pushbuttons and the STOP Button

correctly function.

U003.5-TM70_HH_SYS-R 14

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Keine Kommentare

Cervis TM70 Bedienungsanleitung Seite 18