Cervis TM70 Bedienungsanleitung PDF herunterladen (Seite 25)

Technical Assistance Services (01/08) 22

The first thing that must be checked when we have a breakdown is that the LED of the

button panel lights up green. If it does not light up or turns a steady or intermittent red follow

these steps:

1. Substitute the battery to discard the possibility of it being discharged.

2. Check that the eeprom is properly connected. In case of doubt, it is recommended to

try with another eeprom to check whether the led of the transmitter logic lights up or

not in green.

3. If the led lights up green with the new eeprom, the eeprom will be broken; therefore, we

will have to substitute it with another one, copied from an eeprom and if it does not turn green,

substitute the transmitter logic following these steps:

4.11.- MO70 HYBRID

5. Remove the broken logic

and put in the new logic LE73.

6. Put in place the fastening

support of the removed LE73,

tightening the two screws that

join it to the upper part of the

desk.

7. Place the removed patch

cables in their position,

connect the eeprom and close

the desk.

8. Turn the key to the contact

position and and push and

extract the stop button. The

LED will blink green a few

times and will turn off.

Pressing start, the unit will

begin to work.

3. Remove all the patch cables

of the broken LE73 with the

help of the connector

extraction tool (1179015).

4. Remove one of the

fastening supports of the

LE73, loosening the two

screws that join it to the upper

desk part.

2. Once the broken transmitter

is open, extract the EEPROM

EP7O. Stored in the EEPROM

EP70 are the parameters of the

unit.

1. Open the out of order

transmitter removing the four

fastening screws with a Philips

screwdriver.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare

Cervis TM70 Bedienungsanleitung Seite 25

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen Cervis TM70