Cervis TM70 Installationshandbuch PDF herunterladen (Seite 14)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

1. Connect the charger to the proper power source using adaptor supplied for your

system.



Note: When installing the battery charger, bear in mind:

• Batteries must be charged at temperatures over 41ºF (5ºC) .

• The power supply must be left on without interruption for the entire time that it takes to

charge the batteries.

• The charger must not be left in direct sunlight as the batteries will not become fully

charged at temperatures exceeding 95ºF (35ºC).

2. Place the batteries in the charger. The LED’s should illuminate indicating that

recharging is in process. Complete recharging takes 12 hours. Batteries may

remain in the charger for an unlimited period of time after they are fully charged.



Note: If the LED does not illuminate when the battery is seated for charging, there is

an improper connection. Remove the battery from the charger, check that the

terminals are clean and unobstructed, and reseat the battery firmly in its cradle; check

to see that the LED is on. Should this fail, contact Cervis Customer Support.

The capacity of the batteries decreases with use. Battery life span is estimated to be 500

recharging cycles, but this depends largely on the conditions of use, for which the following is

recommended:

CAUTION

Only use batteries certified by Cervis. When the batteries are exhausted, they

should be safely disposed of or recycled according to local regulations.

Never carry batteries in your pockets with other metal objects where a short

across the terminals may occur resulting in burns or injuries.

3.1 Charging Tips

• Do not recharge the battery until it is completely flat (fully discharged). The transmitter

indicates when the battery is nearing a charge cycle when the LED flashes red; this also

indicates the transmitter will switch OFF in five (5) minutes.

• Always charge the batteries at temperatures between 41ºF and 95ºF.

• Avoid short-circuits between the battery contacts. Do not carry charged batteries in

toolboxes or next to other metal objects (keys, coins, etc.).

• Always keep the contacts clean.

• Never leave batteries in direct sunlight.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 102 103

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 14