Cervis TM70 Installationshandbuch PDF herunterladen (Seite 19)

Operation and Installation Manual

2013 Cervis, Inc.

Table 3. Transmitter Details

Item Number

Indication

Crane Identification Label

LED

Command Controls

Contact Key

Start Button

STOP Button

Option: LA70 Range Limitation

Option: LCD70 Display and LA70 (able to be activated by EEPROM)

Figure 8. Transmitter Details

2. Turn the transmitter ON to OPERATION Mode as follows:

a. Place a charged battery in the transmitter.

b. Turn the Contact Key clockwise to ON.

c. Push in and then pull out the STOP Button. The transmitter LED flashes orange

once, and then illuminates green for three (3) seconds. If the transmitter has an

LCD, it displays the identification of the machine and the battery level.

d. Press and hold the START Button. The green LED should now light indicating

that the transmitter is transmitting. Release the START Button.

3. Upon receiving a signal from the transmitter, the receiver enters into Operation

Mode. The following LEDs will light up on the receiver:

Power ON – indicates that the power supply is OK.

HARDOK ON – indicates that board defects have not been detected.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 102 103

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 19