Cervis TM70 Installationshandbuch PDF herunterladen (Seite 20)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

SIGNAL ON – indicates the working frequency RF signal is being received.

DATA (When) ON – indicates that received data is correctly formatted.

ON – indicates the receiver has recognized the transmitter identification

code.

CAN_RUN ON – indicates that communications with CAN expansion boards are OK.

CAN_ERR OFF

4. STOP relays KSTOP1 and KSTOP2 will be activated. The K2/START relay is

energized when the Start button is pushed.

5. Press any Control function button; its corresponding relay should energize. In

case of an active function, the safety relay K1/SAFETY will also energize. Check

each control in this manner.

6. Turn off the transmitter using the STOP button. Check to make sure all of the

relays are de-energized and that the DATA, ID, and SIGNAL LEDs go out. At this

point, they behave as they do in SCANNING mode.

7. Reconnect power to the motors. Move to the usual working position. Check to

make sure that all Control functions and the STOP button are properly operating.



Note: Neither Cervis or Ikusi is responsible for incorrect installation of equipment,

interferences produced as a result of frequency collisions, or of the working frequencies in

fixed facilities where several radio remote systems share or have the ability to share the

same zone or working area.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 102 103

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 20