Cervis TM70 Installationshandbuch PDF herunterladen (Seite 44)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

Figure 19. TM70 Configuration and Navigation Buttons

Enter Configuration Mode

To enter the Configuration Mode, press the LCD70 ENTER key and then press the transmitter

START button. The UP and DOWN buttons allow menu navigation to select the

preferred software option, and they also allow value selection when a range of values is

available.

The ESCAPE button aborts any selected menu option, and it also allows return to an upper level

in the software menu.

14.4 Data Feedback Operating Mode

The Data Feedback mode can be performed through software or by change using a rotary

switch. Software selection, the default method, is performed using the UP and DOWN buttons

on the LCD panel. Hardware selection is performed by moving a particular switch as determined

on the technical datasheet provided with the system.

14.4.1 Multiple Returns/Multiple Feedback

The transmitter can process multiple feedback of two types of information, but only one type can

be displayed at a time.

1. CAN return + one direct input in the receiver. In this case, the receiver must have an analog

card (IN010V or IN0450P) or a digital card (IN4D) connected to the LR70 card. The INCAN

configuration is not allowed in this case. The receiver is a slave in the CAN bus.

2. INCAN board + one direct receiver input. In this case, any number of analog or digital cards

can be connected directly, or the INCAN expansion card can be used; the CAN return will

be disabled. The receiver is a master in the CAN bus.

Only systems using software revision 2.4.x support direct connect of the feedback signal to the

LR72 card. Regardless, use of the INCAN card option allows simultaneous system management

of several feedbacks using software revision 3.1.x or greater.

The user can select the feedback information to display through software or hardware. UP and

DOWN display buttons allow the user to sequentially scroll through the feedback information.

The priority order of feedback is:

1. Information corresponding to the card—IN 0-10 (2303755-10) or 0-450P (2303758-450P)—

directly connected to the receiver LR72 board.

2. Order for subsequent cards associated to the INCAN inputs depend on the order in which

they are connected – reading from low to high.

The INCAN file and parameters are configured and saved to the EEPROM.

ENTER

ESCAPE

START

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 102 103

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 44