Cervis TM70 Installationshandbuch PDF herunterladen (Seite 26)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

Recessed Philips

Screws

10.0 Programming a Spare Transmitter

The EP70 EEPROM of a spare transmitter can be can be programmed to match the original

transmitter EP70 EEPROM. In the following steps, the original console box is called the Master

while the replacement transmitter is referred to as the Replacement.



Note: In the event that the console is damaged to the extent that its EP70 cannot be

removed, the copy process can be carried out by using the receiver EP70 EEPROM.



Note: Electronic components such as EEPROMs and memory chips

are susceptible to static damage. Take static precautions when

handling. Avoid touching pins and surface connections. Improper

handling may void the warranty.

1. Identify the COPY EP on the transmitter as shown in Figure

10. It can be identified by recognizing the square and triangle

symbols adjacent to the switch.

2. Remove the battery from the Master to ensure that transmitter

it turned OFF.

3. Remove the four screws from the bottom of the transmitter.

Figure 9. EP70 Extraction and Insertion

4. Remove the Master’s EP70 EEPROM.

5. Remove the battery from the Replacement to ensure that it is turned OFF. Remove the

Replacement’s EP70 module.

6. Insert the Master EP70 EEPROM into the Replacement’s EP70 socket.

7. Insert a charged battery into the Replacement console box.

8. Turn the ON/OFF key to ON.

9. Release the STOP button. The unit LED will pulse GREEN for approximately 15

seconds.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 102 103

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 26