Cervis TM70 Installationshandbuch PDF herunterladen (Seite 76)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

22.1.2 Relay Outputs (Terminal RL1)

The connections shown in Table 25 are for the four possible relays of RL1.

Table 27. A1P4RCAN RL1 Relay Wiring*

*K1 through K4 relays rated at 250V@8A each.

Relay

Function

Normally Closed (NC)

Common

Normally Open (NO)

Normally Closed (NC)

Common

Normally Open (NO)

Normally Closed (NC)

Common

Normally Open (NO)

Normally Closed (NC)

Common

Normally Open (NO)

22.1.3 Analog Output (Terminal RL2)

Table 28. Analog Output RL2 Wiring

Name

Function

VOUT Analog Output

GND Midpoint of Potentiometer

–V Power supply Negative (-50V min.)

Power supply Positive (50V max.)

22.1.4 Tele-Teaching (only V3.1 Software or Higher)

The following properties of the Analog Output can be set using Tele-Alignment:

• Maximum and minimum values,

• Polarity inversion

• Acceleration or deceleration ramp, and

• Curve type.

To configure the card for Tele Alignment mode, a bridge must be installed in Jumper P5 (see

Figure 46).

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 102 103

Keine Kommentare

Cervis TM70 Installationshandbuch Seite 76